USL PSA-200U - Manual (Page 4)

Page 4 USL, Inc. PSA-200U Instruction Manual 1st Edition. October, 2004
Review the following safety precautions
to avoid injury and prevent damage to
this product. To avoid potential risk, use
this product only as specified and only for
the purpose described in the instruction
manual.
To Avoid Fire and Personal Injury:
• Use Correct Power Cable. Use only the power cable
provided. Insure that the AC power outlet is located
near the product and is easily accessible.
• Use a Correctly Grounded Power Source. The
Power Supply earth ground is established through
the ground conductor in the power cable. To avoid
the potential of electric shock, the ground conductor
must be correct.
• Observe Source Ratings. To avoid risk of fire or elec-
tric shock, the power source must be 110 - 240VAC,
50-60 Hz
• Do Not Operate this Product with Any Covers
Opened or Removed.
• Avoid Exposed Circuitry. Do not attempt to open
the Power Supply as its safety certification would be
invalidated. The Power Supply is a non-repairable
sealed device.
• Do Not Operate with Suspected Failures. If you
suspect there is damage or malfunction with this
product, call the factory.
• Do Not Attempt Repair. Only a trained factory ser-
vice person is authorized to repair this product.
• Do Not Operate this Product Near Heat Sources.
This product should not be located near heat
sources such as radiators, heat registers, stoves, or
other high temperature sources.
• Provide Proper Ventilation. The operating tempera-
ture should be between 0° C and 50° C. The humidity
should be <90% at +40° C or below and <60% at 41°
C to 50° C. The cooling method is by convection.
• Keep Product Surfaces Clean and Dry. Disconnect
the power cable from the power source before clean-
ing. Do not use liquid cleaners or aerosol cleaners.
Use a damp cloth for cleaning the outside of camera.
Use lens cloth for lens cleaning.
• Do Not Push Objects Into Opening of this Product.
Never insert objects into the product through open-
ings.
• Do Not Operate In Wet or Damp Conditions.
• Do Not Operate In an Explosive Atmosphere.
• Prevent the Spilling of Liquids onto the System
Components.
• Inspect the Power Cable and All Cables Prior to
Use. Confirm that the power cable and other inter-
connecting cables are free from damage.
• Be Especially Alert When Setting Up Product in
Theaters. Establish adequate light. Position cables
to avoid trip dangers. The tripod and camera box
should be carefully and securely attached to each
other. The tripod leg angles should be fully extended
outwardly in three directions for maximum stability.
The leg length extensions can be varied to accom-
modate the inclination of the theater flooring.
General Safety Summary