Triner Scale 600-E Series - Manual (Page 33)

Page A-1
APPENDIX A: SPECIFICATIONS
ANALOG SPECIFICATIONS
Full Scale Input Signal 30mV, including dead load
Minimum Sensitivity - Non H-44 0.4 µV / grad
Minimum Sensitivity - H-44 1.0 µV / grad
Input Impedance 30M Ω, typical
Internal Resolution Approximately 260,000 counts
Display Resolution 50,000 display division max
Measurement Rate 10 Meas/sec, nominal
System Linearity Within 0.02% of FS
Calibration Method Software Calibration, with long term storage in EEPROM
Excitation Voltage +10VDC, 4 x 350 Ω load cells
DIGITAL SPECIFICATIONS
Microcomputer Intel 80C32
Program Memory: 32K x 8, external to µC
EEPROM: 64 x 16, external to µC
Digital Filtering Software selectable
SERIAL COMMUNICATIONS
Serial Port Full Duplex, 1200, 2400, 4800, 9600 Baud
8 data bits, no parity, 1 stop bit
7 data bits, odd parity, 1 stop bit
7 data bits, even parity, 1 stop bit
7 data bits, no parity, 2 stop bits
OPERATOR INTERFACE
Display 0.56" (14 mm) 7-segment, Led, 6 Digit
Additional Symbols Stable, Tare, lb, kg, Zero, Accu
Keyboard 4-key flat membrane panel
POWER
AC Adapter 12 VDC @ 800mA
DC Power Consumption - TI-500E 300mA + 30mA/350 Ω Load Cell
ENVIRONMENTAL
Operating Temperature –10° to +40 ° C
Storage Temperature -25° to +70 ° C