Triner Scale 600-E Series - Manual (Page 17)

Page 2-9
Fig. 2-10: Keypad Cable Detail
3. Connect the display cables from the control module to each remote display (fig. 2-8).
Note: Use option “A” unless there are space constraints.
4. Connect the keypad cable from the control module to the keypad module (fig. 2-10).
Note: Use option “A” unless there are space constraints.
5. Connect one end of the AC adapter to the control module and the other end into a 120-
240 VAC grounded electrical outlet.
6. Once all connections are made, place the stainless cover back on top of the scale.
7. Turn the scale on by using the on/off switch located on the remote switch panel.
8. Test scale for accuracy and proper operation.
Refer to Chapter 7 on page 7-1 for information on General Scale Operation.