Triner Scale 600-E Series - Manual (Page 26)

Page 5-1
CHAPTER 5: USER MENU DESCRIPTIONS AND PROCEDURES
5.1 USER MENU DESCRIPTIONS
This section provides more detailed descriptions of the selections found in the User Menu Chart.
Factory-set defaults are shown in bold with a checkmark (
√).
NAME/CODE DESCRIPTION CODE/VALUE
A1
Baud Rate Selects the baud rate for data transmission through the serial port. 1200 2400 √
4800 9600
A2
Data Bits and
Parity Selects the number of data bits and parity of serial transmission.
"8n" = 8 data bits with no parity bit and one stop bit
"7O" = 7 data bits with odd parity bit and one stop bit
"7E" = 7 data bits with even parity bit and one stop bit
"7n" = 7 data bits with no parity bit and two stop bits
8n √
7O
7E
7n
A3
Mode of Serial
Transmission Selects when data will be sent out of the serial port to a printer or
computer:
"C" = Continuous mode; send data continuously
"d" = Demand mode; send data when a PRINT command is issued
from the printer, computer, or indicator.
C √
d
A4
Display Check Actuates the function that illuminates all digit segments, decimal
points, and LCD annunciators in a test sequence. Pressing the ZERO
key to scroll down one level begins the test sequence. Press ZERO key
to begin sequence
A5
Disable the
lb/kg Key Allows the lb/kg key to be disabled so that an operator cannot
accidentally press the key and change the displayed units.
"0" = Disable the lb/kg key "1" = Enable the lb/kg key
0
1
√
A6
Serial Port
Mode Selects the mode of the RS-232 serial port: Refer to Appendix B for
more information.
"0" = Full Duplex Mode
"1" = Print Ticket Mode
0 √
1
A7
ID No. Enable Allows the ID number to be disabled in the Print Ticket mode. Valid
only when A6 is set to “1”.
"0" = Disable the ID No. "1" = Enable the ID No. 0 √
1
A8
ID No. Entry Actuates the function that allows entry of a new ID No. Valid only
when A6 is set to “1”. Pressing the ZERO key to scroll down one level
begins the sequence. 0 - 199999 (500)
0 - 999999 (500E)
123456
√
A9
No. of Line
Feeds Actuates the function that allows entry of the desired number of line
feeds to be printed in Print Ticket Mode. Valid only when A6 is set to
“1”. Pressing the ZERO key to scroll down one level begins the
sequence. 0 - 99
0
√
A10
Accumulator
Mode Enable
Allows the accumulator function to be enabled or disabled.
0 = Disable Accumulator 1 = Enable Accumulator
0
1 √
A11
Bag Limit
Mode Enable
Allows the bag limit function to be enabled or disabled.
0 = Disable Bag Limit Function 1 = Enable Bag Limit Function
0 √
1