Toa C-CC574 PL - Manual (Page 9)

9
7.2. Mounting Procedures
1. Mount the base unit to the ceiling.
First fix two of the base unit mounting holes as shown below.
Since no mounting screws are supplied with the camera, prepare them separately.
Use screws with a nominal diameter of 4 mm and a length of over 25 mm.
Camera direction
Secure these two holes first.
(Base unit mounting holes)
Open
Ceiling surface
Mounting screws
Mounting screws
Ceiling surface
Camera direction
2. Release the lock on the hinged portion of the base unit and connect the power, video, and signal cables to
the base unit.
(For details, please refer to p. 29; "Connections.")
3. Push up and lock the hinged portion of the base unit and secure the remaining two mounting holes.
Open
Hinged portion
Close