Toa S5 Series Installation - Manual (Page 18)

Page 17 – S5 Wireless Microphone Installation Guide Rev 1.5
Beltpack Transmitter Set-Up
1. Battery Fitting
Open the battery compartment by
sliding the door forward and up. Insert a
battery observing the correct polarity as
shown. The door is marked with a
“Battery +”.
2. Antenna Fitting
Screw the antenna into the antenna bush
3. Microphone
Plug a mic into the Mini-XLR socket.
4. Switch On
Flick the On/Off switch to the “On” position and observe the display is on and
the battery LED illuminated. Check the display indicates the same channel as
the receiver.
5. Check For Received Signal
The receiver should now show a received signal on its RF bar graphs, and
after 20 seconds the transmitter battery status.