Toa S5 Series Installation - Manual (Page 12)

Page 11 – S5 Wireless Microphone Installation Guide Rev 1.5
Miscellaneous Settings
RX Settings
Mute/Squelch Settings
The S5 series uses sophisticated internal mute functions including Pilot Tone,
Noise and RSSI to prevent noise break through from external sources when
the transmitter is in the “OFF” position.
The RSSI (Received signal strength) portion is user adjustable via the RX
SETTINGS MENU. To Access this press the “Jog-Wheel” for 1 second and
enter the MAIN MENU, or for 3 seconds if not in mute.
Rotate till RX SET is underlined and
press. With MUTE underlined, press
the “Jog-Wheel”. Now rotate the “Jog-
Wheel” to adjust the mute setting
between 1 and 10, then press. A
marker shows the current mute setting
in relation to the RF A and B scales.
Please note: high mute settings will
decrease range and low mute settings
increase the interference potential. We
recommend a setting of 4 to 6. The
mute level changes in real time as the
setting is varied.
Audio Processing (S5.5 only)
Press the “Jog-Wheel” to enter the
MAIN MENU. Rotate till RX SET is
underlined then press. On the RX
SETTINGS menu, rotate till AUDIO is
underlined and press. Options
available here are PHASE REV,
LoCUT, and HiBOOST. The default
factory setting for all these options is
OFF. Navigate to each option by rotating the “Jog-Wheel” and press to check
the box for each option when it is underlined.
PHASE REV – reverses the audio output phase.
LoCUT – reduces the low frequency response.
HiBOOST – increases the high frequency response.