Toa SR-L1B - Manual (Page 9)

9
6. SPEAKER STAND FOR SR-F1D
The speaker stand manufactured by Köning & Meyer GMBH (K & M) of Germany is made available for use
with TOA's SR-F1D speaker.
The speaker stand consists of two main sections, which are sold separately.
Stand: Model 213
Bracket: Model 19582
Step 1. Extend the stand's legs.
Loosen the tripod fixing screw and open the tripod
legs outward so that the stays become level.
Then, tighten the fixing screw.
Height fixing screw
Tripod fixing screw
Tripod leg
Stay
Lock botton
Handle fixing screw
Height adjustment
handle
Plain washer
Plain washer
Treaded hole
Speaker mounting screw
Speaker mounting screw
Stand 213
SR-F1D
Stand bracket
19582
Storage of speaker mounting screws
1
2
3
4, 5
Bracket fixing
screw
Tip
To avoid the loss of the speaker mounting
screws, it is highly recommended that the
screws be inserted into the stand bracket
when putting away the stand.
Fully extend the stand's tripod legs and place
the stand on a stable surface. If the tripod is
not sufficiently extended, the stand could
topple over, possibly resulting in personal
injury.
WARNING
Step 4. Adjust the stand height.
4-1. Loosen the height fixing screw.
4-2. Loosen the handle fixing screw and raise the
handle, then retighten the handle screw.
4-3. While holding down the lock button, adjust the
speaker's height by turning the height adjustment
handle. (Clockwise rotation raises the speaker.)
Note
You cannot rotate the handle unless the lock button
is continuously pressed. To complete the height
adjustment, ensure that the shaft is locked when
the lock button is released. (This can be checked
by rotating the handle slightly.)
Step 5. Retighten the height fixing screw.
Note
Leave the handle folded back except when adjusting the
height.
Owing to the speaker's size and weight, be
sure that at least two persons are available to
install the speaker. Failure to do so could result
in personal injury.
WARNING
Step 2. Attach the stand bracket to the speaker using the
speaker mounting screws and plain washers.
Step 3. Loosen the bracket fixing screw, then place the
speaker on the stand.
After setting the speaker's orientation, retighten the
bracket fixing screw.