Toa EV-20R - Manual (Page 7)

7
7. OPERATION
DEL
REC
MONITOR
PLAY
LOCK
0 10
1 2 3 4
USB
POWER
MIC
LEVEL
LINE
REC IN
INPUT / HEAD-
PHONES
START/STOP MODE PHONES/
SPEAKER
4s 2s ON
DELAY
INTERVAL
TIMER
DC IN
GND
SIGNAL
1h 30m
10m
1m
30s
0s 5m
5s
10s
OUT 24V STOP 4 3 2 1
PLAY 1 – 4 / STOP
LINE IN LINE OUT
DC IN
H C E E C H
BUSY
SPKR
Class 2 Wiring / 8 – 16 Ω
24V 400mA
Input Terminal Headphone Terminal
Input Level Selector Switch
Busy Output Terminal
Speaker Output Terminal
Line Output Terminal
Mode Selector Switch Start/Stop Key
Start/Stop Indicator
[Rear]
[Front]
7.1. Recording (REC)
Messages are recorded on the internal flash memory. Up to 4 messages can be recorded, totaling
approximately 6 minutes. Because the recording circuitry features automatic gain control (AGC) function, the
recording level does not need to be adjusted. When the Mode Selector switch is set to the REC position, the
input terminal signal is directed to only the Headphone terminal and Speaker Output terminal, and is not sent
to the Line Output terminal.
Note that the input signal to the Speaker Output terminal is cut when headphones are connected.
Step 1. Set the Mode Selector switch to the REC position.
Step 2. Set the Input Level Selector switch to the appropriate position for the type of
equipment connected to the Input terminal.
Set to MIC (right side) when a microphone is connected, and to LINE (left side)
when other equipment is connected.
Step 3. Connect the microphone, CD player or other equipment to the Input terminal.
Step 4. Press the Start/Stop key for the message number to be recorded, holding it down until the Start/Stop
indicator flashes. Recording begins when the indicator mode changes from flashing to steady ON.
(The indicator begins to flash 1 second after the key is pressed. It changes to steady ON 2 seconds
after flashing begins.)
Step 5. To stop the recording, press the corresponding Start/Stop key again.
Tips
• The Start/Stop indicator begins flashing when only 5 seconds of recording time remain, and continues until
recording is complete.
• Recording over a previously recorded message number automatically deletes the previous recording,
without requiring deletion by changing the Mode Selector switch position.
• Recording cannot be performed from the rear-mounted Line Input terminal.
• Sample chime tones contained in the supplied CD-ROM can be transferred to the EV-20R for use. It is also
possible to back up the messages using the data transfer software program contained in the supplied CD-
ROM. For details, please read the "EV20 Software Instruction Manual.pdf" file located on the CD-ROM.
DEL
REC
MONITOR
PLAY
LOCK
MODE