TeeJet LH 4000 - Manual (Page 20)

LH 4000 O PERATORS MANUAL
20 LH A GRO
METRE SWITCH
Select whether distance-recording is started/stopped manually, "MANUAL", or by
the selected override-service sensor (e.g. spray on/off switch).
INPUT SET-UP
The LH 4000 software allows for a flexible set-up of electric connections to ANY
TYPE of Crop-Sprayer controls. Select either: "MAIN-VALVE" or "BOOM
SECTION”.
The screen will read the current status. You may change setting by using the
"Shut/Open OV." (volt)-key.
E.g.: Boom section “Shut” OV.
States that the wires connected to the boom section switches receive “OV”
(ground), when the switch is in the “OFF” position.
This should be set by the engineer when the system is fitted.
RPM SENSOR
Select weather a RPM sensor is fitted and encode the number of pulses received
per revolution.
NOTE!
This function is not implemented in all sprayer fitting kits, ask your
dealer.
WARNING ENCODE
KM/H: Warning ON/OFF and MAX/MIN. limits for speed warning.
NOTE!
Activation of the speed warning provides and ensures
minimum spray output when the speed-warning is given
for the “low” limit setting. E.g. when the speed falls
below that set in KMH warn the spray pressure will be
maintained.
MIS-
DOSERATE: Warning ON/OFF and Percent deviation of application rate.
LITRE LEFT: Warning ON/OFF for tank level
RPM:
Warning ON/OFF, and max/min limits for RPM.
Only displayed if RPM ON is selected.
DATE-CLOCK
The following can be adjusted:
HOURS - MINUTES - YEAR - MONTH – DAY