5 gpio commands, 6 username/password commands, 7 system commands – Solvline Eddy Series Ver 2.1a User Manual
Page 82: 5 gpio commands -6, 6 username/password commands -6, 7 system commands -6, Table 6-4, Gpio commands -6, Table 6-5, User/password configurations -6

Chapter 6. Configuration via Telnet
6-6
6.5 GPIO commands
Configure operation mode and value for each Programmable I/O pins.
(Only Eddy-CPU and Eddy-S1/Pin modules support this function.)
Table
6-4 GPIO commands
Commands
Default
Descriptions
def gpio <0~15> mode [in / out]
Output
Set current pin’s I/O mode.
def gpio <0~3> value [low / high]
High
Set current pin’s output value. (This option
only applies to output mode pins)
6.6 Username/Password Commands
Configure username and password for Web/Telnet/FTP.
Table
6-5 User/Password configurations
Commands
Default
Descriptions
def username
eddy
Set username to use in Web, Telnet, or FTP.
16 Characters at maximum.
def password
99999999
Set password to use in Web, Telnet, or FTP.
16 Characters at maximum.
6.7 System Commands
Table
6-6 System Commands
Commands
Descriptions
def default
Restore all settings to factory default. Requires reboot for changes
to take effect.
def save
Save current configuration settings. Requires reboot for changes
to take effect.
reboot Reboot
Eddy.