4 serial commands, 4 serial commands -3, Table 6-3 – Solvline Eddy Series Ver 2.1a User Manual
Page 79: Serial commands -3

Chapter 6. Configuration via Telnet
def portviewport
4000
Set the socket number of the PC with Portview
installed.
def snmp
[Enable / Disable]
Disable
Enable or disable SNMP(Simple Network Management
Protocol) support.
▪MIB-II (RFC 1213): System, Interface, IP, ICMP, TCP,
UDP
▪MIB-I (RFC 1317): Serial Interface
def telnet
[Enable / Disable]
Enable
Enable or disable Telnet service.
If disabled, you cannot connect to Eddy via Telnet.
def ftp
[Enable / Disable]
Enable
Enable or disable FTP service.
If disabled, you cannot connect to Eddy via FTP.
Def ddns
[IP Address]
203.32.117.1
If you set DDNS server IP , DDNS service will be
enable. But you set “0.0.0.0” ,this service will
disable.
Def ddnsuser
[username]
eddy
You can access DDNS server with this ID.
Def ddnspass
[password]
99999999
You can access DDNS server with this password.
def web
[Enable / Disable] Enable
Enable or disable Web service.
If disabled, you cannot connect to Eddy via Web.
def target_agent
[Enable / Disable]
Disable
Enable or disable remote debugging function used by
Eddy development environment, LemonIDE®.
For more information, please refer to LemonIDE user
manual in the SDK CD included in Eddy-DK package.
def name
Name of the
module
Set the name of Eddy module. (Max 32 bytes)
6.4 Serial Commands
You can set the communication and operation environment for the serial port. Chapter 5 describes
each option in detail. Only a summary of each option is presented here.
Table
6-3 Serial commands
Commands
Default
Descriptions
def port 1 protocol
[disable / com /
tcp_server / tcp_client /
tcp_broadcast /
tcp_multiplex /
udp_server / udp_client]
com
Select the operation protocol, which the serial port
would use.
6-3