Solvline Eddy Serial v2.5.1.1 - Manual (Page 64)

Eddy User's Guide
64
address, which is composed of 12 hexa-decimal numbers.
Eddy-BT has 4 operation modes as follows:
Mode Description
Mode0 In this mode, there is no response when power on or software reset, and Eddy-BT is just
waiting for AT command input. Neither master nor slave is assigned to Eddy-BT in mode0.
User can change the configuration parameters of Eddy-BT in this mode.
Eddy-BT must be in Mode0, when it is directly controlled by AT commands.
The factory default is set to Mode0.
Mode1 Eddy-BT tries to connect the last connected Bluetooth device.
Eddy-BT in Mode1 is to be a master and tries to connect the last connected Bluetooth
device. Eddy-BT always stores the BD address of the Bluetooth device to which Eddy-BT
has connected last. When Eddy-BT is initially used or after hardware reset, there is no BD
address stored in Eddy-BT. In this case, Mode1 will not be able to work properly. The mode
change to Mode1 can be made after Eddy-BT succeeds to connect to one other Bluetooth
device. Once changed to Mode1, Eddy-BT will try to connect automatically the last
connected Bluetooth device whenever the unit is powered on or software reset.
Eddy-BT in Mode1 cannot be discovered or connected by other Bluetooth devices.
Mode2 Eddy-BT is waits for a connection from the last connected Bluetooth device.
Eddy-BT in Mode2 is to be a slave and waiting for the connection only from the last
connected Bluetooth device. Just like Mode1, if there is no BD address stored in Eddy-BT,
the mode change from other operation modes to Mode2 is not work properly. Once
changed to Mode2, Eddy-BT will wait for the connection from the last connected Bluetooth
device whenever the unit is powered on or software reset.
Eddy-BT in Mode2 cannot be discovered or connected to Bluetooth devices other than the
last connected device.
Mode3 Eddy-BT is waiting for the connection from any other Bluetooth devices. In Mode 3
the Eddy-BT is discoverable and can be connected to by other Bluetooth devices.
Serial Ports
The applicable settings for serial ports are as follows.
Serial Port Settings Values
Baud rate 1200, 2400, 4800, 9600 , 14400, 19200, 38400, 57600, 115200, 230400,
460800, 921600
Data bite 8
Parity No parity , Even parity, Odd parity
Stop bit 1 , 2
Hardware Flow
Control Use , No Use
The values in box are the factory default settings.