Solvline Eddy Serial v2.5.1.1 - Manual (Page 58)

Eddy User's Guide
58
"ReadWrite.”
(Options : ReadOnly/ ReadWrite)
def v3username
[string]
eddy Configure the Username when use SNMP V3.
def v3password
[string]
none Configure the password when use SNMP V3.
def trapip
[address]
0.0.0.0
Configure the server IP address which receives the TRAP
information.
def trapoprt
[Socket No.]
162
Configure the server Port which receives the TRAP
information.
def trap_reset
[enable, disable]
Enable If Enable is selected, inform the "System reset info".
def trap_connect
[enable, disable]
Disable If Enable is selected, inform the "Serial Port opened info".
def trap_disconnect
[enable, disable]
Disable If Enable is selected, inform the "Serial Port Closed info".
def landhcp
[enable, disable]
Enable
If Enable is selected, DHCP server service will be enabled
on the LAN port.
def lanip Address>
10.10.1.1 Set the IP address on the LAN port.
def lanmask
255.255.255.0 Set the subnet mask address on the LAN port.
def lanstart Addrss>
10.10.1.2 Set the start address for the DHCP range on the LAN port.
def lanend Address>
10.10.1.30 Set the end address for the DHCP range on the LAN port.
def leasetime
180 Set lease time for DHCP.
6.4 WiFi commands
Bellow are instruction and function which enable WiFi Network.
명령어 디폴트 설명
def wifi wireless
disable
Determine whether to use Eddy-WiFi module
det wifi mode
[infrastructure
/ ad-hoc]
infrastructure Configure the active mode of wireless LAN