Solvline PB2xxxUG - Manual (Page 72)

SNMP
SNMP(Simple Network Management Protocol) is used by the administrator (SNMP Manager) to monitor
and control the operation status of TCP/IP-based network devices (SNMP Agents) from the remote site.
To establish communication using SNMP, MIB (Management Information Base) between the Manager
and the Agent is necessary.
Portbase supports SNMP MIB-I and II standards.
MIB provided by Portbase (working as an SNMP Agent) is as follows.
9
MIB-II (RFC 1213) : System, Interface, Address Translation, IP, ICMP, TCP, and UDP
MIB-I (RFC 1317) : Serial Interface
Portbase status information is managed by the SNMP Manager, using Get/Set messages stored in MIB.
MIB of Portbase to be registered for the SNMP Manager is stored under the folder ‘SNMP’ in the Portbase
CD.
.
The following functions can be performed with the SNMP applied.
Network Architecture Management
Achieving a map of network hosts is possible, which implies the network architecture.
Performance Management
Many kinds of statistics that are essential to performance analysis can be achieved. These include
network usage amount, error count, performance speed, and response time.
72