Solvline PB2xxxUG - Manual (Page 19)

Set the Portbase IP address for network access.
To configure the network through the Link function(cascaded configuration between Portbases)
of other Portbase, you should certainly set the address to ‘0.0.0.0’. (Only IP Line Type)
Subnet Mask (default:255.255.255.0)
Subnet Mask is determined according to the class of IP address.(Only for IP Line Type)
Gateway Address
A router’s IP address in the same LAN segment as the Portbase(Only for IP Line Type)
Password (default:9999)
Sets password to access the Portbase web page via the web browser.
PPPoE UserName (default: None)
Sets an Identification of PPPoE(Only for PPPoE Line Type)
PPPoE Password (default: None)
Sets a Password of PPPoE(Only for PPPoE Line Type)
NMS IP Address (default:0.0.0.0)
Sets an IP address to communicate with PC where the PortView software is installed.
(Refer to the ‘Portview Manual’ for details.)
NMS Socket Number (default:4000)
Type the socket number to communicate with PC where the PortView software is installed.
19