Setting network with lan port – Solvline PB2xxxUG User Manual
Page 13
2. Setting network with LAN port
1)
Connect the PC and Portbase to the network.
There are two ways to connect Portbase to the network : Direct connection with PC and connection
through HUB. (Connection port that can be used is either LAN 10/100 or WAN port of Portbase)
Direct connection with PC
Connection through HUB
2)
Set the PC IP address among the appropriate range of Portbase IP address.
(The factory default Portbase IP address is “192.168.1.72”.)
3)
Run the web browser on the PC Windows and enter the IP address of Portbase in the address field.
(The factory default Portbase IP address is “192.168.1.72”.)
4)
Configuration via web browser is discussed in Chapter 4 Configuration via Web
13