Chapter 2 configuration, Setting address thru serial port, Chapter 2 – Solvline PB2xxxUG User Manual

Page 11: Configuration

Text mode
Original mode

Configuration

PortBase’s IP address is initially set to a default address, so it has to be reconfigured appropriately before
the first use. You can set the IP address and other operation parameters with Web browser or telnet from
PC, using the LAN, serial, or console port.

1. Setting address thru serial port

1) Connect the Console cable (DB9 to DB9) provided into COM port on the rear panel of Portbase.

2) Run the terminal emulator on the PC. This document describes with “hyperterminal” which is the

standard emulator of Windows.
Open COM port of the PC connected with Portbase.