SIG SAUER P250 - Manual (Page 51)

when it counts ™
www.sigsauer.com 51
10.3 elevation (up/down) adjustment
There are different height combinations available for the front
and rear sights. The sights are numbered according to their
height. you can change elevation by changing either the front
or rear sight. it is easier if you change the front first.
There are six front sight heights available. each front sight
change will move the impact of the bullet approximately 1” at
25 yards.
There are three rear sight heights available (S,M,l). each rear sight change will move the
impact of the bullet approximately 6” at 25 yards.
When changing sights, remember this rule: nuMBerS uP,grouPS uP; nuMBerS doWn,
grouPS doWn. This is true for both front and rear sights (S=1, M=2, l=3).
waRning – sight adJustment
Sight corrections should only be
performed on an unloaded firearm.
Manipulating the sights on a loaded firearm
could result in unintentional discharge,
causing injury or death. Visually and
physically confirm the pistol is unloaded
before making sight adjustments.
do not adJust the sights on a
loaded fiReaRm
impact low of point of aim