SIG SAUER P250 - Manual (Page 36)

36 www.sigsauer.com
8.3 cleaning the Pistol
waRning
never clean the barrel from the muzzle end; do not use a steel wire brush as it can damage the
smooth surface of the barrel. use a suitable cleaning rod and a brush of the correct caliber.
Solvents can be harmful to the surface finish of the pistol. read and follow the manufacturer’s
warnings before using solvents or cleaners. Wear eye protection.
avoid over-lubrication of components.
1. lubricate the cleaning brush with gun oil and
insert it into the barrel via the chamber (opposite
the muzzle end).
2. Wipe powder residues and oil from the barrel
bore and chamber with cleaning patches.
3. clean exterior surfaces of the barrel with a
brush coated with gun oil.
4. remove dirt from guides of the frame, inside
and outside of slide, recoil spring guide and recoil
spring with a brush or cleaning patch. lightly
lubricate same surfaces with a cloth impregnated
with gun oil or gun grease.
5. lightly oil bores of the barrel and chamber.
remove any excess lubricant.
caution: avoid over
lubrication of components.