Vertical Communications EP100 - Manual (Page 87)

CONVERSip EP100 User
Sept ‘04
Comdial 89
To disable an auxiliary mode, select enable/disable button. The light
associated with button turns off and the display no longer denotes the
feature.
7.7 Account Codes
If the installer has arranged your system for account code entry, your
display may prompt you to enter an account code after answering a
call.
To enter account code on an incoming call,
1. If available, press programmed ACCOUNT CODE button (the
call in progress is not interrupted).
2. If not available, press INTERCOM and dial *04 (call is auto-
matically placed on hold).
3. Dial the account code. Your telephone automatically returns to
the call after you’ve dialed the complete account code.
If the installer has arranged your system for account code entry, your
display may prompt you to enter an account code before dialing.
Depending upon how the installer has programmed your system,
these account codes may be “forced”(mandatory) for dialing outside
numbers
To enter account code on an outgoing call,
1. Dial 9 or other line button (the display prompts for an account
code if programmed to do so).
CAUTION
With the exception of a headset micro-
phone, do not connect the audio output of
any external device to the auxiliary jack. Also, do not connect
the tip and ring leads of a telephone line to the auxiliary jack.
Do not connect any devices to the auxiliary jack other than
those mentioned above.