Vertical Communications EP100 - Manual (Page 85)

CONVERSip EP100 User
Sept ‘04
Comdial 87
2. Press TAP to retrieve the displayed parked call.
If you receive a parked call message on your Tracker pager,
1. Go to any system station.
2. Press INTERCOM.
3. Dial Tracker pager orbit code (#800 to #899).
4. Retrieve call.
To enable or disable a Tracker pager at your station,
1. Press INTERCOM.
2. Dial #07 to enable, or dial #06 to disable.
3. Press SPEAKER to end.
7.6 Auxiliary Jack
Your EP100 may be equipped with an auxiliary jack that provides an
interface for a headset, a tape recorder, an external ringer, or an exter-
nal pager. If your EP100 is so equipped, you must set up one of its
programmable buttons to serve as an enable/disable button for each
auxiliary device you plan to connect. The system activates only the
device that it identifies in the display, and activates only one device at
any time.
The following modes are programmable with the auxiliary jack:
• The headset mode allows you to operate your telephone with
a headset instead of as a speakerphone or with the handset.
Connectors on Bottom of Telephone
Auxiliary
Jack
Line Cord Handset
Auxiliary Jack Location
Auxiliary Jack
Handset