Canon ImageCLASS D680 User Manual
Page 81
9-6
3.AUTO REDIAL
Sets whether to perform automatic redial when the other
line is busy or no answer.
ON
Customizes the redial operation.
1.REDIAL TIMES
Sets the number of retries.
1
to 10 TIMES (2 TIMES)
2.REDIAL INTERVAL
Sets period of time between redialings.
2
to 99 MIN. (2 MIN.)
3.TX ERROR RESEND
Redialing is attempted when a transmission error occurred.
ON
RESEND TX FROM
: Sets the number of pages to be
sent when redialing is attempted.
ERROR & 1ST PAGE
, ERROR PAGE, ALL PAGES
OFF
Redialing is not attempted when a transmission error has
occurred.
OFF
After the first attempt at dialing fails, redialing is not
attempted.
4.ERASE FAILED TX
Sets the ERASE FAILED TX function.
ON
The document is deleted from the memory stored in the
machine if a transmission error has occurred.
OFF
The document is not deleted from the memory stored in
the machine even if a transmission error has occurred.
5.TIME OUT
Enables/disables automatic scanning of documents after
the fax number is entered by using speed dialing.
ON
Scanning begins automatically in 5 or 10 seconds after
you enter the phone number.
OFF
Press Start to scan document. Otherwise, the machine
will return to standby mode after 2 minutes while the
AUTO CLEAR
function activates.
RX SETTINGS
Sets the reception functions.
1.ECM RX
ECM (error correction mode) receiving is turned on or off.
ON
All receptions are conducted with ECM if the other
party’s fax supports ECM.
OFF
ECM is turned off.
2.FAX/TEL OPT.SET
When FaxTel has been set, the optional settings are
available.
1.RING START TIME
Sets the duration that the machine listens for a fax tone
before starting to ring.
0
to 30 SEC (8 SEC)
2.F/T RING TIME
Sets the length of time the machine rings to alert you of
an incoming call.
15
to 300 SEC (15 SEC)
3.F/T SWITCH ACTION
Selects the action taken after the F/T RING TIME
expires.
RECEIVE
The machine switches to fax receive mode automatically
at that point and starts to receive the document.
DISCONNECT
The machine disconnects the call.
Name
Descriptions
(The factory default setting is in bold face.)