Oakworks Clodagh Leo - Manual (Page 9)

7
INSTALLATION
INSTALLATION
assembly & installation
installation
The table comes completely assembled and ready to use. Plug the cord into
a functioning outlet that is rated for the table.
Arrange the power cord and foot switch so that they will not create a tripping
hazard. Place the controls in a safe location where they are convenient and
accessible. Keep the controls out of the way of all table mechanisms.
installation
If Table Will Not Sit Flat on the Floor:
The table is equipped with Leveler Feet that adjust to level the table on
uneven floors. To adjust the Leveler Feet to suit common floor dif-
ferences you will need to use a 1 /
2
” open-end wrench or an adjustable
wrench. Adjust each leg individually in turn by adjusting the height of
each leveler foot until the unit rests level and steady. This adjustment
will not effect the function of the table. The feet can be adjusted out 1/2”.
leveling instructions
The table weighs as much
as 232 lbs. (105 kg)
do not
lift or move the unit without
using proper safely proce-
dures or equipment.
do
not turn the table on its side
for any reason. To do so
could cause damage to the
base and
will void the warran-
ty. There are no serviceable
items that require this action.
Never lift the table by grasp-
ing the table top as the
table top is not
designed to
hold the weight of the base
and you could damage the
table.
IMPORTANT 8
Use 1/2” Open-end
Wrench to adjust
Leveler foot
When operating the table’s
controls be sure to observe
all cautions and warnings
given in the manual to pre-
vent injury to both operator
and client.
caution