Caution, Important – Oakworks Clodagh Leo User Manual

Page 16

CARe & CLeANING

CAR

e &

ANING

IMPORTANT

before cleaning with any
liquid cleaner be sure to un-
plug the power cord from the
power outlet. Do not operate
the table in standing water.

be sure to read all

cautions, warnings

and instructions given

in the manual to prevent
injury to both operator
and client.

caution

upholstery

In order to maintain your product’s quality and ensure the life of your upholstery, we

have tested several preventative steps you can take to protect the upholstery fabric on

your table and accessories.
Here are a few suggestions in caring for your upholstery fabric:
• DO NOT store your table or upholstery fabric-covered accessories in temperatures

below 32°F/0°C or above 95°F/35°C. Extreme hot and cold temperatures will

damage the upholstery fabric. Some potential results are cold-cracking, brittleness

and upholstery fabric stretching. And, always keep your table away from heaters,

electrical appliances and direct sunlight.

• We recommend cleaning your upholstery fabric to protect it against oil stains and

dirt which will cause cracking and permanent stains over time. Clean your uphol-

stered items when needed using a mild solution of 4:1 diluted non-alcohol cleaner

such as Formula 409

, Fantastik

, Green Windex

or some other non-abrasive

cleaner. For disinfecting purposes you may use Protex, MadaCide, Accell TB,

Virox

(Canada) or a diluted 1/100 bleach solution. Dry the table immediately after

cleaning to remove excess cleaning solution. Using citrus based cleaners or other

strong cleaners, such as alcohol, acetone, higher concentrations of bleach or other

products that contain high concentrations of these substances, can shorten the life

of your fabric, or discolor it.

Note: Damage caused by cleaners will not be covered under the warranty.

• Protect your table and accessories with sheets and fleeces. We offer both fitted

sheets and thick fleeces that protect your upholstery fabric against oil stains while

offering comfortable softness to your clients. You can also preserve your face rest

and bolsters with covers and fleeces.

• Use only a mild solution of 4:1 diluted non-alcohol cleaner such as 409

, Fantastik

or some other non-abrasive cleaner to wipe down the metal and wooden surfaces.

Apply with a damp (not wet) lint-free cloth. Be sure excess liquid does not drip

onto, or into, any of the electrical controls or mechanisms. Be sure that the unit is

unplugged before cleaning these areas. Wipe these areas dry carefully with a lint free

cloth.

• Electronic and/or manual lift mechanisms require no general maintenance or

lubrication. Hydraulic units may require yearly maintenance.

• If the table will be out of use for an extended period of time, the power cord

should be unplugged from the receptacle. To prevent inadvertent damage to the

plug or cord, the cable should be coiled and secured with a wire tie or rubber band.

• The wooden cabinetry of the equipment can be polished with any polish approved

for wooden surfaces. Spray, or pour the polish onto a soft cloth and be careful not

to get it onto other surfaces.

• It is important to visually inspect your table on a quarterly basis to ensure all

components are working properly and safely. Be sure to tighten all bolts to be sure

they are secure. Over time they may work their way loose, leading to an unsafe

condition.

•

• The face rest and table extender should be removed when not in use.

These items should be stored in a cool, dry place.

base & controls

accessories