Oakworks Clodagh Leo - Manual (Page 15)

DIReCTIONS fOR USe
13
caution
moving the leo™
directions for use
before doing any work on the
table, disconnect the power
cord from the power outlet
and secure the electrical
cord, and foot controls for
moving.
The table weighs as much
as 232 lbs.
Do Not lift or
move the unit without using
proper safety procedures
or equipment.
Do Not turn
the table on its side for any
reason. To do so could
cause damage to the base
and
will void the warranty.
There are no serviceable
items that require this action
.
Never lift the table by grasping
the table top as the table
top is not
designed to hold
the weight of the base and
you could damage the table.
at low height range
Grasp
at base
corner
The Leo™ weighs approximately 232 lbs. (105 kg) You will need 4 people
working together if it is necessary to move the table. Never lift the table by
grasping the table top as the table top is not designed to hold the weight
of the base and you could damage the table and the electronics that run
the tabletop.
If you need to move the table, place one person at each corner of the
table. Have each person firmly grasp the metal leg at the bottom and lift
the table from the base. As when moving any piece of heavy equipment,
bend at the knee and lift with your legs beneath you and not with your
back. Be aware and use proper, safe procedures for
moving a table of this size to prevent injury to yourself or the table.
We strongly recommend that a flatbed dolly be used that can hold the
entire table if moving the table involves any distance.
• C heck that the keyswitch inside the table is in the “on” position.
• Check the outlet to be sure that it has power and that the power
cable is plugged in. Try all buttons on the foot control to see if any
work. If any work, then possibly there is a loose connection or a
faulty controller.
• Unplug the power cable from the wall outlet.
• Make sure that all male and female connectors are firmly
pushed into each other. Even a slight misconnection can
cause a possible malfunction.
• Plug the unit back into the wall and check the controls again.
If one or more of the controls still do not work, contact
Customer Service at 800-558-8850 to arrange replacement/repair.
if the leo™ will not change height
caution
if the leo™ is making noise
during height adjustment
If you hear squealing or a pop during the height adjustment, this may
be related to lack of lubrication in the hydraulic cylinders. We recom-
mend that you immediately cycle the table fully up/down at least four
times. If this does not work, then let the motor cool down for at least 30
minutes and repeat the procedure. The table should return to its normal
quiet mode. Refer to “DIRECTIoNS FoR USE; Important for continued
quiet operation.”