New England Arbors VA84231 - Manual (Page 3)

S T E P T W O
3
Lay out the two carrying beams as illustrated with pre-
drilled holes facing up.
Position the eight rafters over the respective predrilled holes
on the carrying beams as illustrated. Using the 3” screws,
fasten the eight rafters to the carrying beams.
Apply vinyl glue to the inside of the end cap and install
pergola end caps as illustrated.
The Fair field Grande Arbor
Assemble the Arbor Top
1
2
3
www.newenglandarbors.com
S T E P T H R E E
Insert the lattice into the bottom rail as shown.
Note: Bottom rail will have 7 holes on one side only
Insert the lattice assembly into the middle rail.
Note: Middle rail will have 7 holes on the bottom side and 5
holes on the top
Insert the five spindles into the top side of the middle rail.
Note: Top rail will have 5 holes on one side only
Slide the top rail over the lattice assembly.
Repeat for other side panel.
Assemble the Side Panels
1
2
3
4
1
2
3
1 2 3 4