New England Arbors VA94430 - Manual

Check Box for These Contents
In the event of missing or defective parts please call our customer service dept. at 1 800 282 9346, ext #20 (Mon. to Fri. 8:00 AM to 4:00 PM EST).
1. Lamp Post Top (1) 5” x 5“ x 14”
2. Post Coupler (1)
3. Lamp Post Bottom (1) 5” x 5“ x 58”
4. Post Cap (1)
5. Post Collar (1)
6. Base Molding Trim Cap (1)
7. Base Molding Post (1)
8. Base Molding Bottom Insert (1)
9. 1-1/2” Screws (4)
10. Vinyl Weld Glue (1)
Tools You Will Need
• Wheelbarrow or bucket (to mix concrete)
• Tape Measure
• Level
• Shovel
Purchased Separately
• Lamp.
• 4x4 Pressure treated lumber. - 8’ long
• Two bags of pre-mix concrete. *
* Strongly recommended for the stablility of this product.
General Information
• Read Instructions through carefully before beginning assembly.
• When handling components, place on a non-abrasive surface
(i.e. shipping box)
to avoid scratching.
• We recommend an area approx 10’x 8’ for unobstructed handling.
Important Note:
• Please refer to local codes before installing outdoor lighting. UF-rated cable should be used for underground
wiring and all materials should be approved by the Underwriter’s Laborator (UL). New England Arbors
assumes no liability for errors, ommissionsm or the outcome of any project.
The Portsmouth Lamp Post
Please read through before starting assembly.
A S S E M B LY I N S T R U C T I O N S
1
Ver 3/OCT 2010
9
Not to Scale
6 in.
74 in.
8.5 in.
60 in.
3 in.
5 in.
72.25 in.
5
1
4
10
7
8
3
2
6