Mytek Digital Protools HDX DIO Card (ver. 2.0 / Nov 2013) - Manual (Page 7)

Mytek Protools-HDX DIO Card – User's Manual
Card Installation Card Installation Card Installation Card Installation
Only a single Protools-HDX DIO Card can be installed in one
converter. A different format card can be installed in the second
slot. The HD DIO card must be installed in the DIOCARD1 slot,
which is first from the right at the converter’s rear panel.
WARNING!
Remember to follow basic safety rules about handling of
electronic devices while opening the converter:
✔
keep your hands dry,
✔
turn off power and detach power and signal cables
while working with the top cover removed.
To install DIO-HDX card:
1. Find the DIOCARD1 expansion slot at the mainboard’s
layout
2. Check if the power cord and all signal and clock lines
are disconnected.
Before you install the card
in the converter, check if
converter’s firmware
supports DIO-HD card
(version v.4.5.8 or later). If
not, contact your Mytek to
request current version.
User's Manual ver. 2.0 / Nov 2013 www.mytekdigital.com Page: 7 / 32