Mytek Digital Protools HDX DIO Card (ver. 2.0 / Nov 2013) User Manual
Page 6
Mytek Protools-HDX DIO Card – User's Manual
5. Hardware Setup Configuration
Choose Setup > Hardware Setup and check sampling
frequency, clock signal (should be set to Internal) and
confirm Input and Output interfaces are present. Every
converter in the menu should be Set to Default.
6. Routing configuration within converters
The Mytek 8X192 ADDA SOURCE TO DIGITAL OUT
defines sources of audio signals that are sent from the
converter to the ProTools system and all other digital
outputs (all digital outputs are simultaneous). SOURCE TO
ANALOG OUT defines sources of audio signals that are
transmitted to the DAC in the
converter.
6.
I/O signal configuration
In Setup > I/O Setup you can assign signal sources to
interfaces.
7. Input selection – start of recording
Choose preconfigured inputs and outputs in Pro Tools, test
record, and then playback of selected audio tracks.
Remember that 8x192
ADDA converter has eight
channels. For more
information read
master/slave mode section
in this manual.
User's Manual ver. 2.0 / Nov 2013 www.mytekdigital.com
Page: 6 / 32