Mytek Digital Protools HDX DIO Card (ver. 2.0 / Nov 2013) - Manual (Page 30)

Mytek Protools-HDX DIO Card – User's Manual
7. Attach power cord and other cabling.
8. Turn on the converter.
For about 2 seconds no LED's should be lit on the
converter’s front panel, as new software is copied from
memory to the main board chips. Then, all LED's should
turn on momentarily for about 10-20sec, and subsequently
the unit should begin normal operation.
The Protools HDX DIO card also contains a similar
EPROM memory chip that may require future upgrades
should such a need arise due to Protools software
revisions or implementation of additional features.
Check Mytek webpage for information on the latest
firmware versions.
www.mytekdigital.com
User's Manual ver. 2.0 / Nov 2013 www.mytekdigital.com Page: 30 / 32