Mytek Digital Protools HDX DIO Card (ver. 2.0 / Nov 2013) - Manual (Page 19)

Mytek Protools-HDX DIO Card – User's Manual
6. Select each converter and press Set to Default to set the
application in the normal work mode.
7. In Setup > I/O Setup configure the routing according to
your needs, while keeping in mind the 8X192 ADDA
converter has only eight channels. If slave converter was
connected it will be available 16 analog channel's.
Setup > I/O Setup
If the converter is not attached to the Pro Tools systems, it can
be used as a standalone device as if no DIO-HDX card was
installed. The DIO-HDX card is disabled until it is connected to
the Pro Tools systems and computer works.
When the application is launched, control over converter’s
sampling frequency is assigned to software. It is the only
available option in Setup > Hardware Setup which influences
converter’s configuration. Other settings, such as selection of
input or format of digital signal are ignored and should not be
changed. Before launching the application pay special attention
to clock signal source setting in the converter.
Remember that 8x192
ADDA converter has eight
channels. Selecting
channels 9-16 as audio
sources using single
converter will result in no
signal (silence).
User's Manual ver. 2.0 / Nov 2013 www.mytekdigital.com Page: 19 / 32