Mytek Digital Protools HDX DIO Card (ver. 2.0 / Nov 2013) - Manual (Page 16)

Mytek Protools-HDX DIO Card – User's Manual
Output
To playback signal from Protools to the converter's analog
outputs DIOCARD 1 SOURCE TO ANALOG OUT should be
selected. If SOURCE TO DIGITAL OUT is set to DIOCARD1 as
well audio is relayed from the Pro Tools system to the converter
DAC (analog out) and to AES/EBU outputs as well as other
digital outputs if installed.
The actual signal flow in the 8X192ADDA is available in the
form of schematics in the 8X192ADDA manual.
The Protools tracks to be sent to the 8X192 ADDA can be
selected in the ProTools software. In Setup > I/O Setup you can
assign interfaces to signal outputs, later assigned to tracks in the
Pro Tools application.
While track outputs are assigned to channels in the Protools
software, the actual signal routing of the incoming 8 channels to
the converter's physical inputs and outputs must be done
manually on the converter front panel ( SOURCE TO ANALOG
OUT and SOURCE TO DIGITAL OUT). This routing may
initially appear confusing, but after studying the signal flow
diagram in the 8X192ADDA manual you will find it makes a lot
of sense by providing very useful system flexibility.
User's Manual ver. 2.0 / Nov 2013 www.mytekdigital.com Page: 16 / 32