MF Digital CD-5908 (Rev: 08/01/02) - Manual (Page 8)

CD-3706/P
Operator’s Guide
Document Revision: 030501.1 5000 Series
Operator’s Guide
Document Revision:100102
Page 7
The Best Place To Put The 5000
The best operating location for the 5000 Series CD duplicator is in a
climate-controlled area, free of dirt, dust, humidity, excessive heat, and
electronic or electromagnetic interference. Room temperature should be
between 65 and 75 degrees Fahrenheit, or between 18 and 23 degrees
Celsius. Place the 5000 on a solid, steady work surface, and allow sufficient
room for all incidental work materials. Provide at least six inches of
clearance on all sides of the unit for ventilation.
Safety Precautions
The system is shipped with a three-prong power connector, and must be
used with a properly grounded AC receptacle. DO NOT try to defeat the
third “ground” prong. All computer peripherals must be properly grounded,
and the 5000 is no exception. The use of a power conditioner, such as an
Uninterruptible Power Supply (UPS) or a surge protector, is highly
recommended. The minimum required size is 500VA.
Repairs or alterations should only be attempted by authorized, factory-
trained technicians. MediaFORM reserves the right to void the warranty if
unauthorized service is performed.