MF Digital CD-5908 (Rev: 08/01/02) - Manual (Page 20)

CD-3706/P
Operator’s Guide
Document Revision: 030501.1 5000 Series
Operator’s Guide
Document Revision:100102
Page 19
•
Press the “Stop/No” key if you do not want to reset the drive order.
Press the “Start/Yes” key and you will then see the following screen:
O P E N I N G D R I V E S . . .
•
All of the drives will open at this time:
T E S T I N G D R I V E S T A T U S
C L O S E D R I V E T R A Y 1
•
Close the drive tray of the drive you would like to be drive number
“1”. It can be any one of the drives. You will then see the following
screen:
T E S T I N G D R I V E S T A T U S
D R I V E 1 D E T E C T E D
•
Close the remaining drives in the order that you would like them to
read
T E S T I N G D R I V E S T A T U S
C L O S E D R I V E T R A Y 2
• Press the “8” key on the keypad. The screen will now read:
S E L E C T R E C O R D I N G S P E E D
[ 0 ] = 1 6 x [ 2 ] = 2 0 x [ 3]= 4 0 x
The factory setting for this function is “40x”. When selected the
Select Recording Speed feature allows you to set the copying speed
as determined by the capabilities of the recorders installed in the
5000 Series.
•
Press the “0” key to select 16X, the “1” key for 24X, or the “3” key
for 40X. After pressing any of those keys, the screen will now read:
• Press the “9” key on the keypad. Something similar to the following
will be displayed in sequence:
I D L E
D E V I C E 1 [ S C S I ( 1 , 1 )
I D L E
D E V I C E 1 [ S C S I ( 1 , 2 )