Maxim Integrated 78M6610+LMU Evaluation Kit User Manual

Maxim Integrated Hardware

Table of contents

Document Outline

1 Introduction
2 USB Driver Installation
- 2.1.1 Confirm COM Port Mapping
- 2.1.2 FTDI COM Port Trouble Shooting
3 Hardware Setup: Sensor Interface
- 3.1 Simple 2-Wire Single-Phase Measurements Using Shunts
  - 3.1.1 Jumper and Switch Descriptions
  - 3.1.2 Device Configuration
- 3.2 Single/Multiphase Measurements Using CTs
  - 3.2.1 Jumper Position Changes
  - 3.2.2 Device Configuration
4 Hardware Setup: Digital Interface
5 Graphical User Interface (GUI)
- 5.1 GUI Initialization
6 Alternate Sensor Configurations
- 6.1 Split-Phase Using Shunt (On Neutral) and One CT (On Line)
  - 6.1.1 Jumper Position Changes
  - 6.1.2 Device Configuration
- 6.2 Pseudo-Isolated Single-Phase Measurements Using CTs
  - 6.2.1 Jumper Position Changes
  - 6.2.2 Device Configuration
7 Hardware Design Information
8 Contact Information
Revision History