Canon W7250 - Manual (Page 164)

Troubleshooting
40
7-40
Note
Adjusting and Replacing the Cutter
Follow the procedure below to adjust the position of the cutter when the
cutting blade becomes dull and can no longer cut efficiently.
The printer cutter has three positions. Adjusting the cutter to another setting
positions a new part of the blade for cutting. After the cutting blade becomes
dull at the third position, the cutter must be replaced.
z If the notch is already as position 3, obtain a new cutter blade for replacement.
1
If the printer is off, press the Power button to switch the printer on.
After a few seconds “Online” is displayed in the operation panel and the
Online lamp lights.
2
Press the Online button to display “Offline”.
Enter Cancel
Cut Sheet
Roll Media
Paper Source Data Message Power
Online
Enter Cancel
Cut Sheet
Roll Media
Paper Source Data Message Power
Online