Canon W7250 User Manual
Page 134
Troubleshooting
10
7-10
Problem 3: The printhead height adjustment lever is at the down position.
Solution:
Set the printhead height adjustment lever to the center position for normal
printing. (
Æ P.2-25)
Problem 4: You are printing on thick paper.
Solution:
Make sure that the print height adjustment lever is set to the up position.
(
Æ P.2-25)
Edges Smeared with Ink
Problem 1: The selected Media Type is not correct for the media loaded in the paper
supply source.
Solution:
Confirm the current selection for the Media Type. If the setting is not
correct, stop the print job, select the correct setting, then start the print job
again. (
Problem 2: Print media is curled or creased.
Solution:
Remove the creasing or curling then start the print job again.
Problem 3: The cutting dust reduction function is switched on.
Solution:
If the cutting dust reduction function is not needed, use the operation panel
to switch off this feature for the print media in use.
Black Streaks Visible
Problem 1: Printhead is out of alignment.
Solution:
Use the operation panel to adjust the amount of feed for the print media in
use. (
Æ P.7-36)
Problem 2: Printing is not proceeding smoothly due to an interruption in the flow of
data from the computer.
Solution:
Close other applications that are open and cancel other jobs that are
executing.