KERN & SOHN CFS 50K-3 - Manual (Page 20)

6 Unpacking, Setup and Commissioning
6.1 Installation Site, Location of Use
The balances / counting systems are designed in a way that reliable weighing
results are achieved in common conditions of use.
You will work accurately and fast, if you select the right location for your balance /
counting system.
On the installation site observe the following:
• Place the balance / counting system on a firm, level surface;
• Avoid extreme heat as well as temperature fluctuation caused by installing
next to a radiator or in the direct sunlight;
• Protect the balance against direct draughts due to open windows and doors;
• Avoid jarring during weighing;
• Protect the balance / counting system against high humidity, vapours and
dust;
• Do not expose the device to extreme dampness for longer periods of time.
Non-permitted condensation (condensation of air humidity on the appliance)
may occur if a cold appliance is taken to a considerably warmer
environment. In this case, acclimatize the disconnected appliance for ca. 2
hours at room temperature.
• Avoid static charge of goods to be weighed or weighing container.
Major display deviations (incorrect weighing results) may be experienced should
electromagnetic fields (e.g. due to mobile phones or radio equipment), static
electricity accumulations or instable power supply occur. Change location or
remove source of interference.
6.2 Unpacking, Scope of delivery
Remove device and accessories carefully from packaging, remove packaging
material and place device at the planned work place. Verify that there has been no
damage and that all packing items are present.
6.2.1 Scope of delivery / serial accessories
KERN CFS KERN CCS
• Balance (see chap. 2.1) • Reference balance KERN CFS, see chap. 2.2
• Power cable
• Bulk material balance KERN KFP (see chap. 2.2)
• Protective cover • Operating instructions KERN CFS/CCS
• Operating manual • Operating instructions KERN KFP
20 CFS/CCS-BA-e-1422