Canon CXDI-55G User Manual

Page 7

Safety Information

(5)

Recommended Separation Distances

The CXDI-55G is intended for use in an electromagnetic environment in which radiated RF
disturbances are controlled. The user of the CXDI-55G can help prevent electromagnetic
interference by maintaining a minimum distance between portable and mobile RF communica-
tions equipment (transmitters) and the CXDI-55G as recommended below, according to the
maximum output power of the communications equipment.

NOTE 1: To maintain the optimum EMC performance, use only the cables which are designated.

NOTE 2: Do not install the CXDI-55G and Power Box (CXDI SYSTEM II) adjacent to or stacked on top

of or underneath any other system devices.

NOTE 3: Essential Performance in terms of Electromagnetic Disturbances

• No adverse effects on image acquisition
• No adverse effects on image data transmission

Rated maximum

output power of

transmitter

Separation distance according to frequency of transmitter

150 kHz ~ 80 MHz

80 MHz ~ 800 MHz

800 MHz ~ 2.5 GHz

0.01

0.12

0.23

0.1

0.38

0.73

1.2

2.3

3.8

7.3

100

For transmitters rated at a maximum output power not listed above, the recommended separation
distance d in metres (m) can be estimated using the equation applicable to the frequency of the
transmitter, where P is the maximum output power rating of the transmitter in watts (W) according to
the transmitter manufacturer.

NOTE 1: At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.

NOTE 2: These guidelines may not apply in all situations. Electromagnetic propagation is affected

by absorption and reflection from structures, objects and people.

Name

Type of shield

Length

Notes

Power cable

Non-shielded

3 m

Provided with Power Box

Sensor cable

Shielded

7.8 m

Provided with the Sensor Unit

X-ray interface cable

Non-shielded

20 m

Provided with Power Box

Remote switch cable

Non-shielded

20 m

Provided with Power Box

LAN cable

Non-shielded

Max. 20 m

Not provided