Canon CXDI-55G - Manual (Page 20)

– 6 –
4. Operation
4.1 Turning ON/OFF the Power of the System
When turning ON/OFF the power of the sensor unit, refer to the Power Box (sold sepa-
rately) Operation Manual.
4.2 Calibration
Calibration is important to ensure that a good image is achieved with the CXDI-55G by
obtaining the calibration data of the sensor unit. Perform calibration when exposure condi-
tions have changed significantly.
NOTE: For procedure for calibrating, refer to “Calibrating the Instrument” in the CXDI
Series Operation Manual.
4.3 Connecting and Disconnecting the Sensor Cable Relay
Connector
Follow the steps below to connect or disconnect the sensor cable relay connector.
NOTE: Do not connect this sensor unit to the power box other than CXDI SYSTEM II.
It may cause damage to the connector.
In addition, it is necessary to register each sensor unit to the software for control-
ling the system.
For details on registering the sensor unit, contact Canon representative or dis-
tributor.
NOTE: When connecting or disconnecting the sensor cable relay connector, refer to the
CXDI Series Operation Manual, set the power switch on the power box (or
remote switch) to OFF and check that the POWER lamps on the sensor unit,
power box and remote switch are off.
The ERROR lamp will light if the connector is connected or disconnected while
the POWER lamp is lighted.
NOTE: Be absolutely sure to hold the sensor cable relay connector by its grip part to
connect or disconnect it.
Holding the cable to connect or disconnect the connector may break the wires
inside the cable.
If the outer bushing of the grip part is turned, the cable lock can be loosened, and
this can cause a short-circuit of the cable.
NOTE: Do not drop the sensor cable relay connector when connecting or disconnecting
it. You may injure yourself or cause damage to the property or connector.