Juniper Systems Allegro CX Quick Start - Manual (Page 5)

Data Storage Tips
The Allegro CX has a solid state storage drive used to store
programs and data, named the C_Drive. The solid state internal
storage is non-volatile so information stored on it is retained even
when no power is supplied to the Allegro.
The best way to ensure that applications and data are safe is to
store them on the C_Drive or a PC Card. To install an application
to the C_Drive, complete the following steps:
Run the application’s install program, while the Allegro CX is
connected to the desktop PC through ActiveSync.
Click on NO, when asked to install to the Default Installation
Directory .
Select the C_Drive as the destination media, and then click on
OK .
Run the Save System utility by tapping on Start | Programs |
Utilities | Save System .
Battery Gauging Tips
The Allegro’s intelligent battery gauging circuit helps you
efficiently maintain the batteries. The percentage of the remaining
charge in the batteries is displayed in the system tray icon.
The battery gauging is an estimate. It works well in applications
where the Allegro is used heavily and charged every day. When
the Allegro is not being used (turned off), it draws a small
amount of power from the main battery pack to maintain the
internal RAM memory of the Allegro in the same state it was
when it was shut off.
Important Battery Gauging Tip
To avoid battery gauging errors, keep the Allegro attached to the
AC charging adapter or in the USB/Power Dock when not in use.
This practice prevents the battery pack from self-discharging. The
battery stays charged and the battery gauging reflects the correct
status of the battery pack. The Allegro can be left plugged in
overnight and on weekends without harming the battery pack.
Please refer to the on-line owner’s manual found on the Allegro CX
Distribution CD for more information about Batteries and Battery
Gauging. You can order a hard copy of the manual if needed.
1)
2)
3)
4)