Juniper Systems Allegro CX Quick Start - Manual (Page 2)

Setting the Battery Packs Charge Level
The battery charge level must be set before you can use your
Allegro. To do this, complete the following steps:
Tap in the box next to the Enter New Battery Charge Level (%) so
a flashing cursor appears (if not already there).
Set the charge to 10%.
Tap on Accept. A warning pops up stating, Battery charge less
than 50%, Battery Recharge Recommended.
Tap on OK. The desktop opens.
The Allegro is now operational but it needs to remain attached
to the AC wall charger until the battery pack is fully charged
(approximately two to three hours).
In the bottom right corner of the screen, the battery charge icon,
, is shown in the systems tray. It indicates that the battery pack
is charging.
Charge the battery pack in your Allegro until the battery charge
icon goes away and the battery gauge reads 100%. As the battery
pack is charging, complete the remaining procedures in this
guide.
Set Time and Date Gauge
To set the time and date on your Allegro, complete the following
steps:
Double tap on the clock in your Allegro’s system tray and wait
a few seconds for the Properties screen to appear.
Tap on the correct day on the displayed calendar.
Select the time zone you are in.
Note: Select the Daylight savings time in effect option only if it
applies to your time zone.
Set the correct time.
Tap on the Apply button, then tap on OK in the upper right
corner.
Install Acrobat Reader
It is not required to complete this section if you already have
Acrobat Reader installed on your desktop PC. Acrobat Reader is
required for viewing the Allegro CX Owner’s Manual, located on
the Allegro CX Distribution CD.
1)
2)
3)
4)
1)
2)
3)
4)
5)
6)