Philips CDI200/37 - Manual (Page 9)

INSTALLATrON
REMOVING THE TRANSIT PAD POWER CONNECTION
Press the ON/OFF button (7) on the player.
Press the OPEN/CLOSE button (2) on the player to open the disc
triiy(l).
Take the transport pad from the disc tray.
Press the OPEN/CLOSE button (2) on the player to close the
1глу(1).
To avoid damages to the CD-I player when transporting, keep the
transport pad and reuse it whenever you are transporting the
player.
PLACEMENT
Check if the power voltage indicated at the player matches
the voltage of the AC outlet.
Connect the female end of the AC (alternating current) cord
supplied into the AC socket (7) on the player rear panel.
Plug the male end of the cord into an AC outlet.
CAUnON
ONLY A QUALIFIED SERVICE PERSON SHOULD REMOVE
THE COVER OR ATTEMPT TO SERVICE THIS DEVICE.
USE OF CONTROLS OR ADJUSTMENTS OTHER THAN
THOSE SPECIFIED HEREIN MAY RESULT IN HA2ARDOUS
RADIATION EXPOSURE OR OTHER UNSAFE OPERATION.
Place the player on a firm, flat surface.
Keep away from heat sources and direct sunlight.
In a cabinet, allow 1 inch (2-3 cm) of free space all around
the unit for adequate ventilation.
REAR OF PLAYER
8. Power AC (alternating current) input jack.
9. Input2 port for CD-I pointing devices, keyboard or serial
port.
10. Remote (RC6) IN.
11. Video OUT (CVBS).
12. IN FROM ANTENNA.
13. OUT TO TV.
14. Audio output R.
Audio output L.
15. Channel selector.
16. Extension socket (for 22ER9141, See Note).
• For any optional connection accessories you require, contact
your supplier.
CAUTION: NEVER MAKE OR CHANGE CONNECTIONS
WITH THE POWER SWITCHED ON.
NOTE: Digital Video (Full Motion Video) CD-I discs require
the optional Digital Video Cartridge (22ER9141) available from
your local CD-I dealer. For the location of the dealer nearest
you, call 1-800-845-7301.