Philips CDI200/37 - Manual (Page 17)

BEFORE REQUESTING SERVICE
If it appears that the CD-I player is faulty, first consult this check­
list.
It may be that something simple has been overlooked.
Under no circumstances attempt to repair the system yourself;
this will invalidate the warranty.
No power.......................... • Check that the ON/OFF
button (7) is set to on.
• Check that both plugs on the power
cord are properly connected.
• Check that there is power at the AC
outlet by plugging in another appliance.
No picture......................... • Check that the TV is switched on.
• Select the same channel or input on
the TV as that of the piayer or check
the video connection.
Distorted picture............... • Check the disc for fingerprints and
clean with a soft cloth, wiping from
center to edge.
No open icon
on TV screen..................... • Switch the player off, then switch
on again while holding the STOP
button (6) pressed.
No start-up.
Screen does not change
.........................................• Check that the disc label is facing up.
• Clean the disc.
• Check if the disc is defective by
trying another disc.
No sound...........................• Check audio connections.
• If using a HiFi amplifier, try another
sound source.
Distorted sound
from HiFi amplifier........... • Check to ensure that audio
connections have not been made to
the ampiifier Phono input.
No return to start-up
screen when disc is
removed.....................
The player can’t be
remote controlled...
Reset by switching the player off,
then on again.
Check to see if the CD-I program
requires another disc to be loaded.
Aim the remote control directly at the
sensor on the player.
Avoid all obstacles which may inter­
fere with the signal path.
Disconnect the device connected to
Input (rear)
(9).
Inspect or replace the remote control
batteries.
- 1 7 -