Philips CDI200/37 - Manual (Page 3)

Safety Precautions
WARNING: TO PREVENT HRE OR SHOCK HAZARD, DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR
MOISTURE.
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH
WIDE BLADE OF PLUG TO WIDE SLOT, FULLY
INSERT.
LASER SAFETY: This unit employs a laser. Only a
qualified service person should remove the cover or
attempt to service this device, due to possible eye injury.
ATTENTION: POUR EVITER LES CHOCS
ÉLECTRIQUE, INTRODUIRE LA LAME LA PLUS
LARGE DE LA FICHE DANS LA BOIRNE
CORRESPONDANTE DE LA PRISE ET POUSSER
JUSQU'AU FOND.
CAUTION: USE OF CONTROLS OR ADJUSTMENTS
OR PERFORMANCE OF PROCEDURES OTHER THAN
THOSE SPECIFIED HEREIN MAY RESULT IN
HAZARDOUS RADIATION EXPOSURE.
CLASS 1
LASER PRODUCT
WARNING:
This device complies with Part 15 of the FCC CU.S.A.) Rules. Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These Emits are designed to provide reasonable protection against harmful interference in a
residential instaUation! This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular instaEation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the foUowing measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
IMPORTANT:
This product was FCC certified under test conditions that included use of shielded cables and coimectors between
system components. It is important that you use shielded cables to reduce the possibiEty of causing interference to
radios, television sets, and other electronic devices. If you have any problems, contact your dealer.
Any change or modifications to the eqmpment by the user not expressly approved by the grantee or manufacturer
could void the user's authority to operate such equipment.
3 -