In(; the r – Philips TP2785CI User Manual
Page 33
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
S
eti
IN(; THE R
emote
C
oxtroe
T
o
W
ork
W
ei
h
O
ther
D
evices
Searcli Method
y
our TV remote can be set to
work various external devices
such as VCRs, Cable Boxes,
Satellite Receivers, DBS, etc. by
what is called the search method of
remote control programming. If the
“DIRECT ACCESS" code number
method (shown on the previous
page) did not set your remote to
work your accessory device, then
follow the easy steps listed below.
Note: The Search Method only
works with devices equipped with
channel display indicators or
capability.
Please read steps 1-4 before begin
ning.
IBEQINJ
Press the POWER button on
the device your are attempting to
program to turn it ON.
Place the TV/VCR/ACC
Mode Switch in the proper posi
tion.
Press the (A/CH) • RECORD
^'''^and the SMART SOUND but
tons simultaneously and hold them
down.
The device will begin to change
channels after the remote identi
fies the correct code. When the
channels start to change release the
VCR RECORD and SMART
SOUND buttons. The remote
should be ready to operate the
device.
S
m a k i
I l r . l T
w This method can take up to
S two minutes to perform.
Don’t let the device scan up more
than five channels. If you do the
remote may pass up the right code
and another two minute search cycle
will have to be repeated.
If no channel change happens within
two minutes, repeat steps 1-4.
Should a channel change still not
occur, the remote wUl not work the
desired device.
Satellite Receiver
33