Philips FW62C - Manual (Page 9)

CONTENTS GENERAL INFORMATION SAFETY INFORMATION
General Information .................................................. 9
General Information_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Safety Information 9 * The type plate (which contains the serial
numher) is located at the rear of the system.
Preparation .......................................................... 10-11 • Recording is permissible if copyright or other
rights of third parties are not infringed.
Controls ........................................................... 12-14 , Yijjg complies with the FCC rules, part 15
Operating The System ..................................... 14 -16 Operation is subject to
the following two conditions:
CD .................................................................... 16-18 - This device may not cause harmful
interference, and
.............................................................. W - 20 _ Yijjg ifg^jQe gjusf accept any interference
jgpg 21 - 22 received, including interference that may
cause undesired operation.
Aux 22 Environmental Information_ _ _ _ _ _ _ _ _ _ _ _ _ _ _
...................................................................................................... ^ All unnecessary packaging material has been omitted.
Timer ......................................................................... 23 We have done our utmost to make the packaging easily
separable into three mono-materials: cardboard (box),
Recording ......................................................... 24 - 25 polystyrene foam (buffer) and polythene (bags, protective
foam sheet).
Your system consists of materials which can be recycled
Specifications .......................................................... 26 reused if disassembled by a specialized company.
Troubleshooting 27 observe the local regulations regarding the
disposal of packaging materials, exhausted batteries and
old equipment.
Accessories (Supplied)_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Safety Information
Remote control
Batteries (2 x AAA size) for remote control
AM loop antenna
FM antenna wire
AC power cord
1 pair of surround speakers
Before operating the system, check that the operating
voltage indicated on the typeplate (or the voltage
indication beside the voltage selector) of your system
is identical with the voltage of your local power
supply. If not, please consult your dealer. The type
plate is located at the rear of your system.
When the system is switched on, do not move it
around.
Place the system on a solid base (e.g. a cabinet).
Place the system in a location with adequate
ventilation to prevent internal heat build-up in your
system.
Do not expose the system to excessive moisture, rain,
sand or heat sources.
Under no circumstances should you repair the system
yourself, as this will invalidate the warranty!
If the system is brought directly from a cold to a warm
location, or is placed in a very damp room, moisture
may condense on the lens of the CD unit inside the
system. Should this occur, the CD player will not
operate normally. Leave the power on for about one
hour with no disc in the system until normal playback
is possible.
Electrostatic discharge may cause unexpected
problems. See whether these problems disappear if
you unplug the AC power cord and plug it in again
after a few seconds.
To disconnect the system from the power supply
completely, remove the AC power plug from the
wall socket.