Inserting batteries into the remote control, Demonstration mode, Controls operating the system – Philips FW62C User Manual
Page 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CONTROLS
OPERATING THE SYSTEM
Inserting batteries into the Remote
Control_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
* Insert the batteries (Type R03 or AAA) into the
remote control as shown in the battery compartment.
To avoid damage from possible battery leakage,
remove dead batteries or batteries that will not be
used for a long time. For replacement, use type R03 or
AAA batteries.
the preparation procedures.
Demonstration mode
The system has a demonstration mode that shows the
various features offered by the system.
Whenever the
system is switched on from the wall socket, the
demonstration mode will start automatically.
Note:
-
During demonstration mode, if you press any source
(or standby-on) button, the system will switch to the
respective (or standby) mode.
- When the system is switched to standby mode, 5
seconds later, the demonstration mode will resume.
seconds Xo
stop the demonstration.
The demonstration mode will be switched off
permanently.
The system will switch to standby mode.
14