Philips FW62C - Manual (Page 19)

TUNER
Easy Set
EASY SET allows you to store all available radio stations
in a particular band (FM or AM) automatically.
• Press and hold STANDBY*ON (on the system only)
for 2 seconds; when the system is in standby or
demonstration mode.
-* 5CT" will be displayed and followed by
"TMffEf?".
-* EASY SET will start with the last active band.
All available radio stations with sufficient signal
strength will be stored or until 40 presets are filled.
N otes:
- W hen E A S Y SE T is used, all previously stored radio
stations w ill be erased.
- The last preset radio station w ill appear on the display
w hen E AS Y S ET\s completed.
Tuning to radio stations
Press TUNER to select TUNER mode.
— "iUfJilf?" will be displayed.
A few seconds later, the current frequency or the
radio station name if available will be displayed.
Press TUNER (BAND) again to select the desired
waveband ; FM or AM.
Press TUNING ◄◄ or ►► for more than one second,
then release.
The display will show SERREH' until a radio
station with sufficient signal strength is found.
Repeat this procedure until the desired station is
reached.
To tune to a weak station, briefly press TUNING ◄◄
or ►► until the display shows the desired frequency
and/or when the best reception has been obtained.
Storing Preset Stations
You can store up to 40 radio stations in the memory.
When a preset radio station is selected, the preset
number appears next to the frequency on the display.
Automatic programming
1 Press TUNER.
2 Press TUNER (BAND) again to select the desired
waveband : FM or AM.
3 Press PROGRAM for more than one second.
PROGRAM flag starts flashing and 'ffuTD' will be
displayed.
Every available station for the selected waveband
will be stored automatically. The frequency and
preset number will be displayed briefly.
-* The system will stop searching when all the
available radio stations are stored or when the
memory for 40 preset radio stations is used.
The system will remain tuned to the last stored
preset radio station.
• Repeat the above procedure to store other preset radio
stations for the other waveband. Remember to select
the next available preset number before proceeding. If
not, some of the preset radio stations may be erased.
N otes:
- Y ou can cancel the autom atic program m ing by
pressing P R O G R A M or S TO P ■ on the system only.
- If you w ant to reserve a section of preset num bers, for
exam ple preset num bers I to 9, select preset 10
before starting autom atic program m ing: now only the
preset num bers 10 to 40 w ill be program m ed.
19